$79.95 USD $58.95 USD
120CCA, 6Ah (PB Eq), lithium ion motorcycle battery - perfect for custom builds.
Around 6% shorter and 29% narrower than an Antigravity 120CCA battery!!!
Takes up 17% less space than an Antigravity 120CCA battery!!!
They measure a tiny 105 x 65 x 40mm (4.13" x 2.56" x 1.57") +/- 4mm tolerance*.
Weight is just 430 grams (0.95lbs.)!!!
Mountable in any orientation, they can be easily hidden under seat's, etc.
Unlike other lithium ion motorcycle batteries, these have a built in Power Circuit Management (PCM) system which protects the battery from over-charging, over-discharging, over-heating, and voltage overload, ensuring the safety of both battery and bike!
Without a PCM, a lithium ion battery can be permanently destroyed when using a faulty regulator/rectifier as an example. This battery on the other hand will automatically disconnect itself from the electrical system, preventing any damage from occurring. Recharging the battery re-sets it for use again. Note: if this occurs, it is advised to have your electrical system faults rectified, as to continue to operate the battery in this manner will eventually cause permanent damage.
The cells and PCM are first wrapped in 4-5mm EVA padding, then wrapped in epoxy board and finally PVC shrink-wrapped.
Cable length is 75mm (positive cable) and 150mm (negative cable).
Being a fully-fledged motorcycle battery, they are a direct replacement for your original battery. Provides a significant space and weight saving.
No need to give up your electric start! Enough current to start street bikes up to approximately 450cc and race bikes up to 600cc (please check your owners/workshop manual or other sources for the minimum recommended battery CCA rating for your bike).
New Technology, NO-LEAD and NO-ACID Battery.
Longer life than lead/acid. These batteries are not affected by vibration or heat as are lead/acid batteries.
No trickle charging needed. They can hold a charge up to a year! Lithium does not suffer from a "natural discharge" that lead does so it holds it's charge without the need of a trickle charger.
Shipping within continental US only. These batteries must ship with UPS Ground. Please note if you select any other service other than UPS Ground, we will still ship UPS Ground.
*Due to the way the battery is wrapped there can be a variation of +/- 2mm in the final dimensions to what we have specified here. We advise that you do not start making cradles, etc. for this battery until you have received your order and taken your own measurements.
DO NOT USE A BATTERY WHICH IS BELOW THE MINIMUM REQUIRED CCA AS ADVISED BY THE BIKE MANUFACTURER. THE BATTERY MAY BE DAMAGED AS A RESULT.
$32.95 USD $17.95 USD
Mini switch block, chrome plated, low-profile, curved fascia. Suit 7/8" handlebars. Designed by us here at MMCC, we've had the wires soldered on for you as we know how easy it is to destroy the switches by putting slightly too much heat in during soldering....
$32.95 USD $17.95 USD
Mini switch block in black with a low-profile, curved fascia. Suit 7/8" handlebars. Designed by us here at MMCC, we've had the wires soldered on for you as we know how easy it is to destroy the switches by putting slightly too much heat in...
$8.95 USD $6.95 USD - Sold Out
Replacement switch for our low-profile switch blocks. Convert our switch block to dual-pushbutton! Great for controlling horn and start from the same side of the handlebars. The pushbutton is a momentary-on type. Pre-soldered with wires.